Filmes De Travesti Online

Replacing ceiling lamps front center

The dismantling procedure is simple but the Audi does not insert anything in the manual about ...

ceiling with sunglasses holder open front

First you must get a set of screwdriver.

Open you'll notice the sunglasses holder and a screw to screw with the screwdriver that fits.

then pull the lamp from the rear view mirror and you'll find that you come off easily.






Now you just need to unclip and replace one of two lamps from 10W bulb or small lamps 5W indicated by red arrows.

The replacement of two 10W lamps is rather difficult.

To remove, simply push it inward and then flip the lamp to drop it.

To put the new miss a lot of time because you entrarla long into the slot and then turn it and squeezing it from the inside out. So not having the space to perform this maneuver inside the lamp with your fingers around the bulb you will need to run a tape or wire (as in the picture), enter it into the slot and then matching the joints firmly pull up on the band or the wire to the outside.

not forget to try if everything works regularly before closing it.

To put the lamp in the first place enough to fit the back and then the front. Finally tighten the Phillips screw inside the sunglasses holder.

How Old Are Drivers In North Carolina?

Disabling Seatbelt beep

The only thing that bothered me the first time by going in my new Audi A4 was the continuous beep emitted by the onboard computer if they are not fastened belts. It will be a very valuable rule to be respected but often do journeys of less than km and at speeds below 40 km / h we move into private areas and it is annoying seat belt 10 times in half an hour.
Solution: simply remove the pin located under the front and rear seats.

The plug is hanging (Already released) shown in the picture below

driver's seat from the back

and was connected with this' other plug indicated that you see in the picture below.

seen from the driver's seat and pedals

same plug in different location but you will find under the passenger seat.
The onboard computer will detect the belts as input always and all the airbags work properly.

I should point out that airbags perform their function properly only if the belts are fastened otherwise regularly in some cases can be dangerous, so they are tied always .