The only thing that bothered me the first time by going in my new Audi A4 was the continuous beep emitted by the onboard computer if they are not fastened belts. It will be a very valuable rule to be respected but often do journeys of less than km and at speeds below 40 km / h we move into private areas and it is annoying seat belt 10 times in half an hour.
Solution: simply remove the pin located under the front and rear seats.
Solution: simply remove the pin located under the front and rear seats.
The plug is hanging (Already released) shown in the picture below
 |
| driver's seat from the back |
and was connected with this' other plug indicated that you see in the picture below.
same plug in different location but you will find under the passenger seat.  |
| seen from the driver's seat and pedals |
The onboard computer will detect the belts as input always and all the airbags work properly.
I should point out that airbags perform their function properly only if the belts are fastened otherwise regularly in some cases can be dangerous, so they are tied always .
0 comments:
Post a Comment